SGM Studio 12 Betriebsanweisung PDF herunterladen (Seite 29)

STUDIO SC USER GUIDE

5. To PLAY-BACK the track, you must hold down <PLAY> key and then press the track’s key you

have just recorded, exactly at the time you pressed the same key when you record the track

(this is important to obtain a good synchronization with music). The play-back will stop

automatically when the track reaches its end. However, you can stop it any time by holding

down <PLAY> and pressing the track key. The SINGLE or LOOPING PLAY is selected by

pressing the <MODE> key: the led on the button <PLAY> shows the mode (OFF=single /

ON=looping).

EXTERNAL TIMING

To use the Studio as a slave of an SMPTE device, just connect it, through a 3 pin XLR cable, to an

SMPTE source (video recorder, computer, ...) and then proceed as follows:

1. Set the starting time in the source and put it in “pause” (example: if you have a tape of 120

minutes, you can set 01:23:45:00...).

2. Press and hold down keys <ENTER> & <PLAY> for at least 4 seconds, until the led blinks.

3. press a key of the Register section (1...24) selecting the track to record. If the track was

already done, then it will be replaced.

4. When you are ready, you can “PLAY” the source (video recorder, ...) and proceed to record

your show selecting the output memory for each show period.

5. When you want to STOP the recording, hold down the <PLAY> key and press again the track

key you selected previously.

6. To PLAY-BACK the track, you must rewind your source (to the previous starting position), put it

in pause and then hold down <PLAY> key and the press the track key you just recorded. The

play-back will stop automatically when the track reaches its end.

7. However, you can stop it any time holding down <PLAY> and pressing the track key.

SGM Light Technology 12/12/2000 Ver. 2.04

1 2 ... 24 25 26 27 28 29

Keine Kommentare

SGM Studio 12 Betriebsanweisung Seite 29